Menu
"The product and hardware were top notch. All parts were included and instructions were clear. Best of all they worked very well and the post was secure! Thanks for a well-made product."
-Alan E., Post Anchor Customer
*This is the single anchor without hardware. If you need fasteners, check out the Post Anchor Kit.
BEAUTIFUL WOOD POSTS ON ANY SURFACE, FASTER AND EASIER THAN EVER BEFORE.
The Titan Wood Post Anchor™ makes it possible to install wood posts on decks, privacy panels, pergolas, and gazebos by surface mounting to wood, composite, concrete or stone surfaces with a low visibility connection for a cleaner look and longer life.
Please check and observe local building codes in your area before installing this product.
Surface mounting posts, where possible, increases the longevity of a post. The low profile look of the post anchor gives you improved appearance compared to many wrap around style brackets.
Includes hardware for a wood surface installation:
(8) 1/4 x 4" FlatHead Screws
(4) 3/8 x 5" HexHead Lag Screws
Optional Post Brace for maximum strength (sold separately)
With the Titan Post Anchor, you can enjoy the beauty of wood posts without big, unsightly, ugly, anchoring brackets on more surfaces.
No notching decking
No complicated carpentry, framing or hardware
Posts are higher and drier for longer life
Use an off the shelf 1-1/4" dia. by 2" deep hole saw to cut a pilot cut for the tube.
Use a 1-3/4" dia. hole saw for 6x6 and 8x8 post anchors.
Use a 3 lb mini sledge to drive tube into post beyond the depth of hole saw cut.
Pre-drill holes and drive lag screws into the post.
A sharp-edged,lightweight, rigid tube cuts deep into the core of the wood post and holds thepost and anchor together longer than just screws alone. This makes the connection more visually appealing. Where more strength is desired, use an optional Post Brace.
A truly innovative and effective solution.
To properly secure the post anchor to a wood surface, ensure that there is wood blocking like a 2x6 or 2x8 below the deck boards and between the joist.
Pre-drill the screw holes if they are too close to the edge of a board to prevent splitting.
The same principle applies to composite and synthetic deck boards. It's a good idea to pre-drill the screw holes so the screws can drive in easier without snapping off the heads. The composite and synthetic material can be very dense and sometimes similar to hardwoods.
Set one screw to secure the anchor while pre-drilling the other holes. Drill 1/2" deeper than the length of the screw.
Once the holes are drilled, remove the template anchor and position the post and anchor over the holes for attachment.
One concrete screw per corner is enough to keep the post and anchor secure given the pull-out resistance of each screw.
All Proline (PR) post anchors are hot zinc galvanzied, powder coated and feature countersunk screw holes.
This model will work with posts between 3-½" and 4" square.
This model works with nominal 4x6 posts and up to true 4"x 6".
Great for railings, pergolas, pavillions and support columns. Secures posts between 5-½" and 6" square.
The model is often used for large timber construction projects and secures posts between 7-¼" to 8" square.
The 4x4 and 6x6 Post Anchorshave been tested by Intertek for certain limited residential applications inthe USA and Canada. It may not be suitable for guard rails in your area. See Intertek engineering reports for guidance about your intended use.
© 2023, DecksGo Powered by Shopify